[stump]

Update..update...
Ok..well, the wheels/tyres are under control...the zorst is all sorted, including a new rear pipe section to the muffler......
Thought I'd turn my attention to some suspension work.....You've no doubt seen that I painted the coilovers green, like TEIN.....but not..
And that I want a lowered stance.....well, these kits have rubber grommets at the top of each strut, which just press-fits into the chassis...
IF...I leave the grommets off....I effectively save about 4mm in height...
Soooooo....how do I attach the coilovers...? Glad you asked.......
..
...
....
.....


Almost ALL of the chrome part at the top is enclosed in the grommet, so you can see how much I'll save in height...


New pipe to rear muffler...I made the bends a lot smoother this time...


Also filled the tops of the chassis rails...they will be very visible and did not look very 1:1 if left in their molded "open" state....
I've also cut the top section of the radiator support and firewall from the body. They will be attached to the corresponding sections on the chassis, helping to eliminate unsightly joins....
The radiator section is to be all new...look more realistic, I hope.....


Stay tuned guys...I'm on an 8 day break from work, so things are gonna get hectic round here......
Thanks for following along too, your participation is most welcome....
cheers
Greg