Hey guys,
I've had the same problems and replaced the driver side HUB hoping my lights would go off, but they didn't
I came to the conclusion to replace the hub due to the fact that the Multimeter did not read any voltage in the wheel sensor itself even with the whole harness hooked up.
Does anyone know the exact voltage and resistance values for the sensor and the wiring harness going into the sensor?
Im hoping with those values I can pinpoint the problem. I could take the easy way out and find an ABS capable scanner, but as I am in school, I think ill do it the hard way first
I will also check the wiring harness for any water, kinked, and exposed wires from defective insulation.
Cheers!