[big white bufflo]

EVERY ONE run chebby why dont you be differant and stay true to AMC ! not i dont blame you AMC is very rare and lots of money is needed for performance parts here are some ideas i have a 65 rambler 220 with a 401 if i were to go chebby i would use a motor plate that mounts to the front of a chevy and use those ledges on each side of the engine bay the ones below the batt tray on each side use them for the front support and what i did to syrangthen the body from flex i built my owne frame ties running frome the inside of the front frame to just in front of the rear springs there is a lift point cut thatout and sanwich the frame there then make a rear cross member for the tran if you good on fabrication i should not take but a day or two to do that the rear end i used a ford 8in out of a mavirec fit real nice the only trouble is you can only fit a 8in tire in the stock well there is not much room because the rear springs i ran slick running 12.20 1/4 mile but have plans to take rear sping out and run a four link with same frame set up i told you about good luck and hope i was of helpany other question just post them ii will try responding