|
Re: 92 S10 4x4 4.3L Motor Mounts
Just looking at the '92 manual and it looks the same as any Chevy V8 mount.
Support the truck properly on jackstands. Raise the engine a half inch or so but don't support the weight by the oilpan or front pulley.
Remove the long bolt & nut in the mount that runs parallel to the crankshaft then remove the 3 mount to engine short bolts. Remove the old mount, install the new mount then start & tighten your bolts.
There's no mention of removing the front differential, driveshaft or transfer case.
|