Quote:
|
Originally Posted by duh1
well, no luck so far. when i adjusted the valves there was no compression. should i turn the engine over for a few seconds to pump up the lifters, or should i just back off each rocker arm nut 1/3 turn on all till it fires up, or what. i am completely confused now. however, i feel i have established tdc on the compression stroke of #1, it lines up with a mark on the balencer, and both #1 pushrods are at their lowest levl equally.
|
You need to check the opsite firing cylinder for the valve rock to get the true top TDC compression stroke.
When valves are all of the way closed on a cylinder .
Back off rocker arms on that cylinder untill you can spin push rods by hand.