Quote:
|
Originally Posted by loots42
When I had the TC shift motor off, I put an open end wrench on and was able to shift to 3 distinct positions just fine and easily using the 14mm wrench. So I'm pretty sure at this point that it's not a mechanical problem of binding with the TC.
I put it back on and it still only shifts between 4LO and 4HI, but not to 2H. After trying to shift about 50 times, it'll then shift to 2H.
MT-2500 - the 4wd light is not on. The Chilton manual I have say I must have a OBDII scan tool (I know the cheap ones won't read tc codes), and does not outline the procedure manual procedure to ground the test terminals to get flash codes. Is there another way to get the codes?
|
Go back and read post no 4.
When you get codes post back code no.
For good repair info.
http://www.alldata.com/products/diy/index.html