Quote:
|
Originally Posted by loots42
I took the shift motor off today. I supported it with the wires still attached. The truck was in 4LO wen I took the motor off. As I press the shift button to 4H, I can see it turn from the lo possition to the high position. And then when I press the 2HI, it shifts in the exact same manner as when selecting 4HI. What it does is tries the shift twice. Since It isn't actually hooked up to the Transfer Case, it defaults back to 4LO.
So can I conclude it's not the transfer case motor? Any other ideas for this problem?
|
Proper testing will give you the answer.
Check for codes.
Get the all data sub to guide you along.
AND HELP YOU OUT.
http://www.alldata.com/products/diy/index.html
GOOD LUCK