Quote:
|
Originally Posted by Bads Crew
This it?
. Close all the vehicle doors.
2. Insert the ignition key into the ignition lock cylinder.
3. Press and hold the door unlock switch.
4. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
5. Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
6. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to four transmitters.
8. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
9. Operate the transmitter functions in order to verify correct system operation.
Easy as pie!
|
I bought a truck that only came w/ one FOB so I bought a spare key FOB from ebay and was starting to have my doubts about using ebay when it didn't come come with the instructions as promised. I searched and searched google for free programming instructions and didn't have any luck until I stumbled upon this site. These instructions worked flawless on my '98 ZR2 w/ factory keyless entry. I printed these instructions out, walked out to the truck and within a min. or less I had a new programmed remote. I made sure the FOB I purchased from ebay had all the same numbers before buying it...which is probably which most don't think to do before they buy.
Make sure the remote you purchase has matching numbers and these instructions will work. At least it did on my '98 S10 truck. Thanks a bunch!