|
I use Testors Stop Light Red Metallic. I'm sure that its not that different than any of the other clear reds. Its a very thick paint, but I believe thicker is better for this application. I take the tail light and go around the edge with a black permanent marker for my first step. This adds a little realism (doesn't look good on all models though). Then you apply the clear red. I brush on a thin layer all over the back of the light. Be sure to leave certain areas clear, such as reverse lights, etc. You probably know that though. Hold it up to a light and make sure its evenly coated. Let it dry and do the other one the same way. (Also, never paint the front of the light. It looks way too unrealistic.) Now take your clear red and really lay it on. I take a big glop of clear red and place it right in the middle. Use your brush and spread it out to the edges and all (don't go over them though!). Hold the piece up to the light. You should see a little bit of light pass through, not too much. Go back and apply more paint to areas that are lighter until you are satisfied. Make them so they have uniform and level coats of paint. Don't be too conservative with the paint. It's all going to be behind the lens anyway. Hope this helps. :bandit:
|