Well it took six hours but I have my rebuilt 1.0L installed. I think I'm
getting too old for this. I cant move today from crawling under that
Metro half the day.
But I did run into a problem. When I tried to switch over my crank
timing belt gear it wouldnt come off. I covered the gear but not
good enough and messed up the the teeth. So what are my options on
finding another one for my 94? The top timing belt gear has two notches and
i'm not sure what one to use to get my timing correct. Not sure why
they would make it with two notches. Someone mentioned to look on
the back for wear in one of the notches.
Also, can the distributor be put on backwards or incorrectly? I
seems to be seated good but this concerns me.
I pulled just the engine and we had a hard time seperating it from
the tranny because we didnt remove the access plate for the
flywheel/belhousing. Stupid me