Quote:
|
Originally Posted by tempfixit
Did you check the resistro for continuity? Double check the fuses. Have you checked the relays for AC and blower motor? I would also inspect the fans switches and controls for bad connections at the panel.
|
Thanks for the reply tempfixit. Can you give me a little information on checking for continuity. I've rebuilt motors before but electronics are beyond me. I have a digital volt meter but I'm not sure on what Ohm setting I should put it on. I have 200 2k 20k 200k and 2m.
Setting it at 200 and connecting the two exposed metal tabs I get a reading of 2.5. I get the same reading from the top left and bottom right poles of socket. where I plug in. Below you can see all my readings from different configrations.
[X]
[ ] [ ]
[ ] [ ] 2.5
[X]
[ ]
[X] [ ]
[ ] [X] 2.5
[ ]
ON the other two poles I get .7
[ ] [] [x] .7
[x] []
[ ]
[ ] [X] [X] 1.7
[ ] [ ]
[ ]
[ ]
[ ] [ ] .5
[x] [x]
[ ]