View Single Post
  #5  
Old 07-10-2008, 09:06 AM
jdmccright's Avatar
jdmccright jdmccright is offline
The RustBuster
 
Join Date: Feb 2006
Posts: 2,290
Thanks: 1
Thanked 51 Times in 50 Posts
Re: Accelerator sticking again!!!!!

It is possible that there is dirt and crud inside the cruise control actuator. You don't mention if this happens when the cruise control is on or off, but the throttle and cruise control are mechanically linked through that actuator. If it is sticking, then it ought to be replaced...I do not know if the unit can be opened for repair or cleaning.

Does the CRUISE light on your instrument panel flash when you turn it on? If so, there is a trouble code stored in the ECU. Download the Body Electrical System service manual stickied at the top (BE) and read the code (page BE-168).

Another but less likely possibility is that the little magnetic clutch that engages the cruise control is not disengaging or has a short circuit. This may also require replacement of the actuator.

Perhaps you can disconnect the cable from the actuator to the throttle to prevent this until you can look at it?
__________________
Current Garage:
2009 Honda CR-V EX
2006 Mazda 3i
2004 Chevrolet Silverado 2500HD
2003 GMC Envoy XL
2000 Honda ST1100
2000 Pontiac Sunfire

Vehicle History:
2003 Pontiac Vibe AWD - 1999 Acura Integra GS - 2004 4.7L Dakota Quad Cab 4x4 - 1996 GMC Jimmy 4wd - 1995 Chevrolet C2500 - 1992 Toyota Camry LE 2.2L - 1992 Chevrolet S10 Ext. Cab 4.3L - 1995 Honda ST1100 - 1980 Yamaha XS400 - 1980 Mercury Bobcat.
Reply With Quote