[dsdr12]

Checked continuity of the EGR valve tonight. According to my manual pins 1/5 should create a circuit as should pins 2/4. I checked and to not get continuity on 2/4. I also checked the old valve I took off and same thing, nothing on 2/4. So either I got a bad valve or I blew the valve after putting it on the car. I am going to get a new valve tomorrow. Do you know what the voltages should be at the connector? I am getting 5.0 volts on pin 4 and 13.3 on pin 5. The pin 4 voltage is correct according to my book, pin 5 voltage is not listed.
I'm going to bring my meter and check the new valve in the store.