View Single Post
Old 05-06-2008, 06:55 PM   #4
jayjp200
AF Newbie
 
Join Date: Dec 2007
Location: TORONTO
Posts: 95
Thanks: 7
Thanked 1 Time in 1 Post
Re: How to reset and relearn the ECU

There was a very good piece of information shared by one of our friend here on this forum. I believe it was on the "hesitation"
It worked very well for me...
This is what it basically said.....


Dont Forget,, If the battery has been changed, Was the Idle setup correctly?
You can relearn the idle by disconnecting battery for a few mins. Connect battery, and start engine. Let it run until its HOT Idling to 700ish rpm.. Better to do this when engine is already hot.. This way you wait two mins or so.. They say 1 min - NO LESS and in Park!!
Then, Put your Shifter in Rev 10 seconds or so, Then Net, then Drive, then 2, then 1st.. If you have OD and D Just do them ALL!
Then back to park, then Take it for a DRIVE!




Thanks to the person who shared this one.
Regards,
Jay
jayjp200 is offline   Reply With Quote