I've looked at the trans cooling lines on my 95 in anticipation of doing a flush but don't see a good place to disconnect it other than right at the trans. Everything is high pressure, so there are no clamps and I don't want to cut into it. I guess the only alternative is at the radiator connection. I don't recall anyone saying to disconnect it there. Lastly, the "hi" or "hot" or the line leaving the trans is the top line and/or the line going to the top of the radiator, right? And just to throw out there, someone on the forum suggested temporarily switching the lines to reverse the flow to backflush the cooler as part of the total flush, clean, fluid and filter change. I think they meant to only send the fluid through the cooler backwards to the bucket and NOT back into the trans. Don't want any crud going in there. I ask mostly to encourage getting this info out here. Thanks!
