Well I'm in the home stretch now! The body has finally been glued to the chassis for good. With it on I could focus on adding the windows and final details. This probably the last update before it's finished.
I used MCG PE window braces. After they are bent up, I drop them in some blacken-it to give them and even flat black finish. New quarter windows were made up from .005 clear sheet plastic, and detailed with Pro Tech PE bolts. The fuel filler and vent line are also all finished up.
The hood was detailed and installed next. All it needs is the inner pivots and hood tethers.
Underneath, every thing has been finished up. New drive shaft safely loop, rear fender tins from embossing metal, and front and rear fender supports made from Detail Master #2 hard line.
And finally my 1:1 hand complete with Go Diego! band aid showing off the inner front crush panels....
Thanks for looking, and thanks for all the comments along the way!
ClayK