Quote:
|
Originally Posted by Morphe
Hi, I'm new to this forum .. I though it might be the most appropriate place (this tread) to ask this question:
Does anyone as the shematics of the ABS wire harness *( right side)? I know that mine is defective ... but I'm not willing to pay what the dealer is asking. I'm gonna remove mine, and remake one using the same connectors *( or new one if necessary) and high grade wires (insulators, protectors, etc).
It's for an Alero 2000 Gx, with 2.4L engine.
It sounds rediculous ... but I'm sure there's not more than 6$ of wire in this + 10$ of connectors.
Thanks for your help!
P.S.: .. nice job for for the hubs ... last time I did mine was on a mercury mystique .. it tooks 10 tons of pressure on a hydraulic press to remove them!  |
Welcome to AF.
I've got the GM Factory Service Manual for the 2002 Alero/Grand Am which may be similar. Are you looking for wiring termination points or point to point wiring? The harness from the hub feeds over to the ABS Modulator which also has the EBTCM module used for ABS and traction control. Located driver's side on the engine cradle/subframe under the inner apron area.