Hey all, just started working on my "interior beutification" project... Here's some pics of the start of my fiberglass speaker pod and some pics of the start of the floor for the back-seat/hatch area...
Picture of the sub-pod pieces after being cut from 3/4" MDF... The "peanut" shape will be the base of the pod:
Pictures of the pieces being test-fit together. You can see the general shape of the pod taking place:
Pics of the pieces glued together from different angles:
Next step is to stretch the fleece and add resin. Then I'll re-inforce the inside with fiberglass matting, and reinforce the outside with fiberglass cloth, then sand/bondo. Then it'll be painted yellow to match the interior trim pieces. The subs (two 10" Kicker solobaric S10's) will be mounted inverted with the magnets outside the box...
Pictures of the hatch-are floor that I made. There is alot of clearance room underneath the rim/tire, and that's where I'm mounting my battery and 1 farad cap... Still in the process of making a template for another "floor" section where the back-seats used to be... that will be where the sub-pod will be mounted...
Hope you like. I'll post more pics as I progress...
P • E • A • C • E
Mike T.