Quote:
|
Originally Posted by ryba85
Has anybody had the idler arm replaced on an 04 silverado? What does it cost to have done or is it easy to do myself? I have moderate knowledge but I'm not sure about that.
|
i have done alot of front end part replacing on many gm vehicles but not the idler arm on a silverado you will need a tool to remove defective part from center link and a large wrench to unbolt from frame not too hard a job. i was wondering why this is defective as my idler arms are still very good . i did replace a tie rod inner on this vehicle it was because the rubber boot lost its seal. it is fairly easy to do. also have both wheels off ground and usually the alignment will change. if your FE has grease fittings give them a hit every 6months especially before cold hits do not grease fittings in very cold temps..........