|
Re: 93 S-10 Clutch Master Cylinder
assuming it comes with the line, unhook line from slave cylinder under truck. fluid will leak out...no problem. make sure you have some FRESH dot 3 brake fluid. remove rod from pedal and clutch master cylinder. there are bolts/nuts holding it to the bulkhead(firewall). they could be inside under dash, or outside on the clutch master cylinder...don't remember. remove those and wiggle it out. install is just the reverse, and then bleed the system VERY WELL. should be good togo.
__________________
Disclaimer: I am not perfect, i may be wrong in my advice from time to time. Also note that any advice given is as is with no warranty whatsoever, and i have zero liability if you get hurt for not being safe while working on your vehicle.
|