ok...here we go again
Really not bad, BUT room for improvements :-)
...if I go full detail there is something to change
-The openings for the brake coolings are solids but I want them hollow, just like the real thing
-All the vents must be opened. Only one is open (triangles) all others will be cut out later
The two cooling ducts are cut out allready. I was really scared that I will ruin the kit
The most scary part is nearly finished, the new ducts are in.
....don't ask how many times the parts broke off and I also solderdd some nice holes into the body..scary stuff
Here you see the new opened colling openings, now there are five.
Metal added from behind.
alot of filling has to be done
The skirt between the cooling ducts was cut away also and has to be redone from scratch.
After a little primer the whole thing doesn't look to bad. The PE meshes are allready bend and test fitted...a lot of modification to the openings where necessary to make them fit. Then will be painted seperately and attached as the very last step to make painting and polishing the body not to hard.
more to come
daniel
-germany-