|
rpm activated switch
OK, this is like the 5th thread I made on this. I cant seem to get the information I need, I have a rpm activated switch which Im hooking to a LED light to use as a shift light.
The rpm activated switch has;
-white wire = going to tach wire by distributer
-black wire = going to ground
-red wire going to 12 v source ( I wired to the back of the accesory socket to the yellow wire )
-yellow wire to LED bulb. ( the other side of the bulb is the problem)
The LED bulb has two prongs, the one is hooked to the rpm switch and the other side requires a +12 wire. I hooked it to the same wire as I did for the red wire, the accesory wire, right beside it. Is this hook up correct, because it didnt work, if not, which +12v wire should I hook it to?
|