It's a KMA (Kennesaw Mountain Accessories.) It actually was put together pretty well from the start, but I did have the usual KMA difficulties...no plate on the top of it, they forgot the license plate bracket, etc. On the plus side, it only cost me $160 shipped.
It has the KMA design, 3/16" sheet metal bent around a 1/4" wall 2x4 that spans the frame rails, and 1/4" 2x3 tha runs into the frame rails.
I was just up at the EOE shop, and Todd finished cutting the mounts off and putting on new, longer ones (that actually make it to the boxed portion of the frame) so it would align to the body w/ the body lift. Unfortunately I don't have any pics of that, but here are two pics from right when I got it (I painted it grey to match the trim a while after I got it.) Christ, my truck looks low in these pics...
I've said it before, I'll say it again...if someone were to start producing these with good build quality and some semblance of customer service, they would probably sell really well. Just don't buy one from KMA...