I made this batch for my old MR2 model to experiment with my new method...
I have it so each plate prints .5" x .25", with the resolution shown here.
The "MRTURBO" plate is on it now, only in the rear. I need to scribble some black markings in the red squares for the reg. sticker.
I got some Scotchlite from Home Depot in the form of an address number. I'd love to find a stock of blank Scotchlite. I printed these plates onto plastic transparency (high res at work!
) and experimented with the best way to attach the clear plastic to the Scotchlite. I'll put pics up when I get them, but I tried white glue, clear gloss lacquer and Future, and so far the Future has turned out best. They're all pretty brittle, though, and the plastic likes to peel away from the Scotchlite.
I need to find a way to print directly onto the Scotchlite, but the pieces I have are too small....