Went out and removed Window motor today and cleaned the motor and greased gear box.. Knowing the 2 revits had to be drilled which I did a while back I went with the cut to access the 2 bolts that were hard to get to. Seeing this now you can use a drill bit larger than the 7mm or 8mm to drill a hole to access the bolts.I would say two 15mm holes would work with room to spare for the nut driver.. I posted some pictures on my photo page. Starts out with the cut off tool I used at the end of page 2 and all of page 3 has the rest.. Hope this helps. Gary
http://good-times.webshots.com/photo...02424945qhHROR