[tempfixit]

To remove distributor:

Step #1- Disconnect negeative battery cable

Step #2- With the distrubtor Cap ON, pick a spark plug wire close to firewall and a spark plug wire on the other side of cap. Mark them so you know which wires you referenced too. Use a straight edge that is long enough to set across the 2 spark plug wires you choose and touches the fiewall of the vehicle. Mark the firewall with a marker of some kind to show the exact setting of the distributor. Disconnect the electrical wires to distributor.

Step #3- REMOVE DISTRIBUTOR CAP. Using a straight edge again mark the location of the rotor on the firewall.

Step #4- Remove the bolt that holds the distributor in place. Slowly lift the distributor upwards, ( If I remember correctly the rotor will rotate counter clockwise) Once it stops rotating again use straight edge and mark location of rotor on firewall.

To reinstall reffernce to your markings on the firewall in reverse order and your engine should start.

These engines can only be timed with a scanner so take your time and you sould be allright.

Hope this helps and goodluck