[gthompson97]

Check your clutch switch. By jumping across the connector, you went right from the ignition hot wire to the starter wire, which is why it would start. The only other wire that runs to the relay is the clutch switch, which is connected to the hot wire from the ignition.

Disconnect clutch pedal position switch. Clutch pedal position switch connector is located at clutch pedal. Depress and release clutch pedal position switch. Using ohmmeter, check continuity between clutch pedal position switch terminals. If continuity exists with clutch pedal position switch depressed and does not exist with switch released, switch is okay. Replace if necessary.