Ok thank you very much for the help. But it didnt work.
Im not sure if you knew exactly what im talking about.. and I really wanna get this fixed bad.. so I'll go over it again. Sorry everyone who reads this.
On the back of the gauge cluster there are 3 wire harnesses with clips connecting to it. If you are looking at the gauges there is one on the left, and two on the right. One of the ones on the right has a black clip, the other on the right is a white clip. On the left its a white clip again.
Right dead center and in the back of the entire cluster is a cylindrical connector that connects to a black cylindrical clip with a pin in the center.. that in turn goes to a wire that goes out a small rubber gasket into the engine bay.. I traced that wire and it goes down behind the engine (on the firewall side) and connects way down there... almost barely reachable.
Now my problem isnt that I cant get the white and black clips connected (the three left and right ones). My problem is that I cant get the cylindrical one connected, the wire isnt long enough.. and I cant stretch it any father..
PLEASE ANYONE HELP ME!!!!