[hatchman]

we're doing a swap in a 97 civic ex coupe (obd2). the engine that we are going with is a obd1 jdm gsr. my question is that i'm using the ex wire harness and almost everything plugs in,(i changed out the distributor and alternator to get those plugs to work and i hard wired obd1 injector plugs to the obd2 harness let me know if i shouldnt have done that) but there are 2 plugs that i cannot find a place to plug them in on the obd1 gsr. "plug 1" was located behind the alternator on the back side of the ex engine and a wire ran from there to what seems like the inside of the engine next to the main engine pully and thats not on the obd1 gsr. "plug 2" is on the top of the fuel rail of the ex engine, its in the same cluster of wires as the injectors, but i cant find out where to plug this in to the gsr engine. and finally (sorry so long of a message) we are ordering an obd2 to one conversion harness and i was wondering if when thats installed do we still have to do wiring changes or do we just plug it into the obd1 ecu and crank it up.
RECAPP
what are those 2 plugs?
and do i still need to add or change wires in the harness with the obd2 to obd1 conversion harness from Skunk 2?