|
Re: fan not working
ok i am finally getting around to trying and figuring out why my blower fan is not working on high. i checked all the fuses and they are fine. The relay that is in the fuse panel works as well as i switched it with another relay and got the same effect. so i pulled out the resistor pack and i only have 2 resistors on my little board and they both looked fine. i could not find any wires that were burnt off or corraded. so i pulled the resistor pack apart because there is a relay inside of it. when i had the fan on the number 4 setting there was about 8.4 volts running to the fan, when i switched it to number 5 the relay clicked so it was in the close posistion and nothing would happen. does this mean that i have to replace this unit?
|