|
Re: Overdrive
Usually the wires in the shifter get a short inside. Unscrew the bolts or screws holding down the shifter to the body and pull the shifter up a little, you should see the wires. My wires were all shredded and burnt so I just cut them off and added new wires. If the wires are ok then try cutting the wires off and twisting them together, this should cause the OD to engage (light goes off). That would indicate a bad switch. In a pinch you can just twist the wires together, tape them up, and put the shifter back in, problem solved, you just can disengage OD, which is normally fine.
|