Thread: 96 accord-Front discs removal question
View Single Post
  #2  
Old 07-30-2007, 03:10 PM
jeffcoslacker's Avatar
jeffcoslacker jeffcoslacker is offline
Lactose the Intolerant
  
Join Date: Aug 2004
Posts: 6,410
Thanks: 4
Thanked 52 Times in 51 Posts
Re: 96 accord-Front discs removal question
1990-95 Accord
See Figures 4 and 5
  1. If equipped with an air bag, disconnect the negative battery cable and properly disable the Supplemental Restraint System (SRS), as detailed in Chassis Electrical .
  2. Loosen the lug nuts, then Raise and safely support the vehicle on jackstands.
  3. Remove the wheels.
  4. Remove the steering knuckle from the vehicle. Please refer to Suspension & Steering for procedures.
  5. Remove the 4 bolts retaining the hub unit to the steering knuckle and remove the hub unit.

Fig. 4: Remove the 4 bolts retaining the hub unit to the steering knuckle and remove the hub unit/rotor assembly
  1. Remove the 4 bolts, then separate the hub unit from the brake rotor.

Fig. 5: Remove the 4 bolts, then separate the hub unit from the brake rotor

To install:
  1. Assemble the disc to the hub unit and tighten the bolts to 40 ft. lbs. (55 Nm).
  2. When installing the hub to the knuckle, use new self-locking bolts and tighten them to 33 ft. lbs. (45 Nm).
  3. Install the steering knuckle.
  4. Lower the vehicle and check for proper brake operation.
  5. If equipped, enable the SRS system and connect the negative battery cable.
Pretty sure '96 is the same...
__________________
You made three mistakes. First, you took the job. Second, you came light. A four man crew for me? F**king insulting. But the worst mistake you made...

...empty gun rack.
Reply With Quote