The shifter handle is just held on with a horseshoe clip in the front side. SHould see the cut out where its hiding.
The break levers out side part should slide of the stick which will stay in.
The other things are usualy just held on with screws.
The console its self is held with torx screws if I'm not mistaken.
Might want to use some spray lube on the seat bolts if they are rusty, it'll make it easier to assemble too.
I would recomend using zip lock bagies to hold all those clips, screws and nuts.
I hate having left over parts..
Oh and take your time with fitment before you start making cuts for the edges and around things if its not already cut.
Good Luck !