Quote:
|
Originally Posted by MPWR
I think you're going to be in for a bit of a challenge soldering an Exacto blate to an aluminum tube....
The best way to remove a door is to have a new door (say a resin one from a transkit) to install in the hole the original door was removed from. Cutting apart a door from a body and having both still be usefull is harder than it would seem.
But if I were going to try it, PE saws would be the way I would go. Here's my review of Crazy Modeler's set. |
Thanks for the link to your review
. I don't have a resin door to install, but I figure I can always buy another kit to use a second body.