Welcome to the forum.
You have already determined the problem is with fuel delivery, you need to know what the fuel pressure is before going any further. Post the results when you have them. Here are some guidelines for checking fuel pressure:
Fuel pressure is not monitored by the On Board Diagnostic (OBD) system and therefore cannot set a Diagnostic Trouble Code (DTC), or illuminate the Service Engine Soon (SES) light.
Fuel pump operation:
The fuel pump circuits are designed to energize the fuel pump through a relay continuously any time the key is in the START position. When the key is in the RUN position the fuel pump will operate provided the engine is running. If the engine stalls, or is not running for any reason, the PCM/VCM will shut off the fuel pump approximately 2 to 3 seconds after the key is turned to the RUN position.
Fuel pressure test:
Install the fuel pressure gauge to the test port near the distributor. Turn the key to the RUN position but do not start the engine. While the fuel pump is running, fuel pressure must be 60-66psi. After approximately 2 to 3 seconds, the fuel pump will shut off. Fuel pressure must remain between 55-60psi for several minutes. A drop in pressure below 55psi indicates excessive leak down. The most likely place is the fuel pressure regulator, the lines under the upper intake manifold, or an injector.
Here is a link to an inexpensive yet ample fuel pressure tester:
http://www.harborfreight.com/cpi/cta...emnumber=92699