Quote:
|
Originally Posted by Techedguy
I have replaced both of them on my 03 Grandam which should be pretty much the same just a little newer. To do this you must first take off the front brake and brake calipers and brackets. Use a piece of wire and tie the caliper and everything up out of the way so that you do not have to disconnect the lines. After this remove the rotor. Once the rotor is removed you can use an Inch and 3/8 socket (six point) and an impact gun to turn off the old axle nut. After that turn the wheel as far as you can in the direction of the bearing you are working on and on the back side of the bearing (towards the axle) you will find four bolts that hold the bearing in place. These are going to be rather tight, and you have to make sure you get on them straight, because if you strip one of them you are going to be screwed. I also don't recommend you heat any bolts or anything because of the close proximity to the cv boots) Next is where a second person can really comes in handy. You have to use a pry bar to get between the old bearing and the housing that it sits in. After you get it to pry lose in one spot start working your way around to keep it coming out even and not getting jammed. After it is out a half inch or so use two pry bars, one on each side, to brace the bearing out while someone else puts the round end of a ball peen hammer into the divot on the end of the axle and use another hammer to beat on the head of that one in order to knock the axle out of the bearing because it will most likely be rusted in. I know this sounds kind of harsh, but if you don't do it you risk pulling the axle out of the tranny and then you are in a world of hurt. After the axle breaks free of the bearing your almost ready to pull the bearing completely free, but first you have to remember to disconnect the abs wires on the back of the housing. Next just clean everything up and put it back together in reverse order and make sure to get everything tight when going back together so nothing can vibrate apart going down the road. The first one took me about 2 and a half hours, the second one about 1 and a half. Hope this helps and good luck.
|
Thanks for ther info, very helpful as i;m a old school guy.
One question - Are those 4 bolts in the back of housing metric or maybe allen wrench or Torx?
As i said i work on Am. Hot rods so i want to have right tools ready
Thanks again for reply