The rear panel, also made of the same soft aluminum as the sides, received the same SMS Hi Def C/F treatment as the sides. Here you can see the first largest single decal panel applied. The holes were cut out with a sharp knife after the decal had fully dried.
I like to use semi gloss black as a base because it dries faster than high gloss and is glossy enough to not cause silvering problems. These decals are dense and opaque enough that any base color will work, but they work much better over a painted surface than raw metal, plastic or resin, like all decals.
Here it is finished.
It took several decals to cover all the edges and contours. Not difficult, just time consuming. It is best to decal a part like this over several days, a little at a time, letting each application dry before proceeding. Once all the decals were dry it was clear coated with the same 50/50 mixture of Gloss and Dullcotes and treated to the same finishing techniques as the sides. As you can see it works well to hide the seams, if you get them lined up when you are decalling...