Thread: How to replace Hub Assembly (bad speed sensor)
View Single Post
  #4  
Old 03-12-2007, 06:10 AM
57chevyragtop 57chevyragtop is offline
AF Regular
  
Join Date: Jul 2005
Posts: 355
Thanks: 9
Thanked 1 Time in 1 Post
Send a message via MSN to 57chevyragtop
Re: How to replace Hub Assembly (bad speed sensor)
Well G, I looked at the autozone site for the repair guide but they no longer have free access to Alldata. And they don't have the repair guides for the 2000-2005 Impala yet. Be sure the replacement was not born in china, try to go with Moog or Timken or other good brand (my opinion). Remove wheel, Brake Caliper & Rotor...ABS electrical connector, rear hub to knuckle bolts (these you access through hole in hub one at a time) torque new hub to 55 ft. lbs. (75Nm), Rotor, then caliper, tourque bolts to 81ft. lbs (110Nm) being sure all mounting surfaces are clean and free of rust or debris..re-connect ABS electrical connector.
Last edited by 57chevyragtop; 03-12-2007 at 12:53 PM.
Reply With Quote