Quote:
|
Originally Posted by Bassasasin
AHH... great info.... thanks.. My wife's security light is on all the time, no matter which key I use...
And to reset? Obviously not by disconnecting the battery!
I have confidence in my keys at this time and wife dont like seeing the light. It just appeared a week ago.
|
There is a 30-minute programming procedure that does not require a scan tool.
1) Turn the ignition switch to START, then release it to
the ON position (the engine will not start).
2) The “Security” light should be ON. After 10 minutes,
it should turn OFF.
3) Turn the ignition switch OFF and after five seconds,
repeat steps 1 and 2.
When this procedure has been completed three times, turn the ignition switch OFF. The control units will exchange the correct commands during the next start-up attempt. If programming is not completed correctly, there will be either no theft protection or the system will lock in antitheft mode and the engine won’t start. Try the programming procedure again. Note that this will not reprogram key recognition,
only the information transmitted on the Class 2 data link.