|
Camber kits are generally required for drops over 1.4" The rule for this is simple-for each 1" of drop there will be a change of -0.75 degrees in Camber from where you started. 5th gen Preludes are spec'd at 0 degrees +/-1 degree for the front. The rear is similar. Do not buy camber kits until you have completed lowering the car and have had it aligned. Get the printout and then you can order kits. I used Ingalls #3571 and 3573 on the rear and Specialty Products #67135 up front. These parts were installed after my Neuspeed Sport/Koni "yellow" setup was put on. (Bought them from Ultra Performance-BTW)
You have other Q's on this-drop me an e-mail.:flash:
|