View Single Post
Old 02-11-2007, 10:31 PM   #1
critter07gt
AF Newbie
 
Join Date: Feb 2007
Location: jacksonville, Florida
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
gst feels like hits rev limiter at 4500-5000

ok so im going nuts here. first off let me give you the set up.
shes a 98 mitsu eclipse gst. 5 speed tranny, 20g turbo from greddy , fmic with hard piping, 750cc inj. , afc (now un installebd) greddy type s bov, walbro 255 fuel pump, adj fpr, greddy exahust 2 and a half in from down pipe back with a high flow cat, 10 mm plug wires, ngk pluggs, have 10.1 vortec fmu but havent installed yet, greddy profec b boost controller, and evolution turbo timer, new maf sensor. and i think thats it on the mods.

ok so i had the car tuned 5 or 6 months ago i hit 315 hp @ 20 psi boost. and all was good for a couple of months. I babied the hell outta the car got on it once in a while but i take care of it.

ok so now the problem the car suddenly started feeling like it hits a rev limiter at 45oo rpm and wont rev any higher in any gear or in neutral.
and turbo is spooling perfactly no shaft play and no leaks.
the car isnt overheating.
there is no knocking or ticking from the engine. and i run 93 oct. fuel always
and use synth oil. changed frequently.
so i did pluggs and wires it fixed the prob for like a week.
i did tune up again and no fix.

im getting cel the codes i pulled are fuel trim malifunction bank 1 (p0170) , Idl. controll fuel and air metering (P0505), Manifacture controlled fuel and air metering (p1105, and Cylinder 4 misfire (p0304).
a friend told me to pull out the afc so we pulled it out and no fix. i turned the boost controller to 6 psi so as to not damage things but the car wil hold what ever boost level i set the contr. to with no boost creep and no lagg its great. but when i hit 4500 i hit a brick wall she just acts like rev limit. I cleared all codes and cel stayed off for 2 days but the problem was still present with no cel on.
we put on a new maf, no fix. compress test 150s to 160s across the board, boost leak test found no leaks. my ///// out // line on the boost controller was not on all the way so i fixed that and still no fix. i noticed that my wastegate actuater isnt moving at all on spool or blowoff i thought this was an issue so i tried to move the wastegate by hand and it wont move but i was told that was normal that it is hard to move and that as long as im geting boost that the wastegate was good and working. its an internal wg. i dont know if thats true but its ony a few months old
anyways im going to put new coils plugs and wires on and see what happens
but i doubt thats going to fix the issue.
timing is dead on. i have ratteled many brains arround here and no one knows whats going on. any advice would be appreciated. i tried resetting the ecu with no results. the only other thing i can think of is possably the ecu is damaged some how. but ya thats about it. let me know what you all think.
ohh and one more thing when i pinch off my return line off the fpr the car dies. I dont know what my fuel pressure is currently at but nothing was changed prior to having the issue. and yes i changed the fuel filter and no fix. eeeerrrrrrgggggg.

Last edited by critter07gt; 02-12-2007 at 11:30 AM.
critter07gt is offline   Reply With Quote