|
Re: 95 Maxima Sensor and suspension problems.
All starts from verifying charge voltage, then connectors see p14
The camsensor produces two signals, seems that ECU doesnt receive the 120 -signal at all. Oscilloscope on the sensor connector, then to ECU pin, will give definite answer... harness problem can aso be tst bypassed by adding single wire parallel from sensor to ECU. There u need schema, seek via link below.
On page 5 is the typical ECU CONT relay nostart problem. ...swap relay, u may mix/swap tst with same color relays. Check brake pedal sw...
Suspension needs some 'crowbar exercise' while feelin/watcin for worn bushings.
|