|
Re: HELP ASAP! Missing balancer belt!!!!!!!!!
I never hurt my engine once running without the front shaft for that year i could see.
anyways here is what mine looks like after the elim. kit install.
It was a rubber seal and did not like the press in fit so i made a stainless steel plate to go over it. Had to take the new seal out since it was a brand new assembly and put the plug in. And if you ever decide to get the elim kit make sure you get the one that has the groove in the oil pump shaft stub. I also cut the balance shaft sprocket down to a spacer that sits behind the timing belt on the crank. It is also a balanced spacer now lol
And this is where you would plug the hole off for the balance shaft belt sprocket, oil will pour if you do not plug that hole.
And here it is done with timing set.
__________________
Current Cars
2006 Eclipse GT 6 speed MT (V6 3.8), mods so far- S Tech Springs, after market 18's, 2012 headlight Conversion, Greddy cat back exhaust, CAI, RRE Headers, Polyurethane Motor Mounts, NX Nitrous kit at 100 shot for now, RPM Window Switch, Triple Pod.
2003 Grand AM GT - official beater car for the winter lol
----------------------------------------------------
95 TSI AWD [email protected] (T-25)
Now fully Modded engine with 3,560 miles on it.SOLD
|