Hello,
Thank you everybody for your nice comments.
I will not forget to make a tutorial about making (simple) schocks with a motor tool..., I swear....!
So here is a little UP.
As the Chassis is almost finished, I started on the interior. I have to finsh most of the work on it because I need to install it on the chassis, to see how the door I've cut, will fit......
So, as I wanted to make the seat ,not moving, but you know, to move on itself (I don't know to say it in english.....), I had to cut those in 3 pieces.....
I also filled the relief with Putty, as I had to made a "Daytona" upholstery (thank you for the picture Stevensky...)
So here are the pics...
I put to lenghts of wire on the headrest, to make him moveable....
I began to work at the back of the seats, as those make by Revell, are not very correct.....
Here is the headrest put in place on the seat (not glued). I need another work on the seatbelsts assembly, and so on.....
Then I began to detail the "Daytona" look on the seats, using plasticard strips....I also drilled holes (3 per side, and 6 on a row, with a 0,4mm Drill)
Here 2 close ups from the work on the seat....
That's all for today? I really hop you like the work I'm doing, as there are so many Master Modellers on this forum.
Sorry for my really bad English.
I'm waiting for your Comments, questions and Criticisms....
Thank You once Again.
Jamme