|
Re: 1997, 3.1l Lumina - ignition mystery?
OK, before disassembling anything I decided to check the failure once again.
I erased the code and tried to start the engine with the key.
Then I re-scanned the codes but found nothing.
OK, to be on a safe side I switched everything off, disconnected the scanner, turned the key to ON/RUN, then to OFF, plugged the scanner in - no DTC codes.
I assume that the security failure P1655 appeared once in the dark past and then it was stored till I read and erased it.
---
So now I have a vehicle that doesn't report any errors but the starter circuit is somehow blocked.
Where does the "final starter wire" come from? From the ignition lock or from the ignition module? The former requires the steering wheel removal, the latter can be reached by steering column unmounting and Haynes' circuit diagram is too general in this part.
|