Quote:
|
Originally Posted by vzfox
Again, more issues with my 1989 GMC C1500 ext cab. Just yesterday I installed new front rotors, bearings and brake pads. I also replaced one of the rear wheel cylinders (it was leaking). After doing all this, I bled the brakes on each wheel, pumping the brakes about 6 times per wheel (I am using a "one man bleeder bottle with tube" since I have no helper) and made sure there were no air bubbles when done. I also bled the master cylinder (via the bleeder screw). I made sure the master cylinder never ran out of fluid. The brake pedal was hard/stiff when I was all done with the truck off. I started the truck when I was all done, and the brake pedal is really soft and goes almost to the floor....causing the brake light on the dash to come on.
What did I do wrong and what can I do to fix this issue....ughhhhhh! 
thanx. |
System still has air in it or the M/C is gone and not pumping the fluid.