Quote:
|
Originally Posted by David12345
1990 olds cutless supreme SL
Well I found two remotes in my dash, because one of my fuses went out and I was going to replace it. I spent about $5.00 for new batteries and find out it doesn't work. So I was looking around this site I found a few thread about reprograming the remote but the link to it didn't work. If someone can tell me the sequence to reprogram it that would be nice or give me a site to it, I would appreciate it.
The keyless entry is a
TRW
P/N: 12522338
Doc/mdc: 218 K1200
Model/FCC: ABO 0110T
|
On my 91 Cutlass Cierra and 95 Cutlass Supreme SL, the remote receiver in the trunk has a connector on it that is used to program the remotes. You short the connector pin to ground (91 actually has two pins. One is ground and you just had to push a screwdriver into the connector to complete the connection to ground) and you should here the doors lock/unlock within 2 seconds. then you push UNLOCK on your remote and you should hear the doors lock/unlock within two seconds. Then push the UNLOCK on the second remote and the doors should lock/unlock within two seconds. Remove the connector pin to ground connection. Your two remotes should now work. (I.e. you are programming the receiver to accept the remotes).