Quote:
|
Originally Posted by maxwedge
Welcome to AF. One can of freon may not engage the compressor. Jump the pressure switch and try it again. Is this why you replaced the compressor, because the clutch wouldn't engage. Checked the compressor relay in the relay panel?
|
Also, the low side pressure was reading 35psi after adding the one can. Shouldn't that be enough to make the compressor work?
I'm thinking either the sensor on the high side is bad, or, like you said, the relay is bad.
I also disconnected the electrical connecters and used a volt meter on all three electrical connectors going to the compressor and could not get any voltage on any of them with the AC on full blast in Max recirc mode.