Quote:
|
Originally Posted by capriceowns
I was looking at the comp cams beehive ones, and they make some specially for LT1 LS1 and stuff like that but they have a universal one. the 1/445 is its outer diameter they dont give any more on it.
Do cam bearings need to be put in by a shop? my block doesnt have any in it right now.
|
Yes, cam bearings are pressed in and the two rear bearings are a little smaller in diameter than the front three. You can do it if you have the special tool, but having a shop do it is cheaper than the tool if you don't intend to rebuild a few of these.
__________________
1988 9C1 - Modified LM1 @ 275HP/350TQ - TH700R4 - 3.08 8.5" Disc Rear - see it at
http://www.silicon212.org/9c1!
2005 Crown Vic P71 - former AZ DPS - 4.6 liters of pure creamy slothness!
1967 El Camino L79/M20 old school asphalt raper
Remember - a government that is strong enough to give you everything you need, is also strong enough to take everything you have.