|
Re: New Drive Axles installed - issue with hub
I had some trouble with mine when I did alot of front end work. The groove for the snap rings came up just short.
Check to make sure no needle bearings came out of the inner bearings on the spindle and are hanging things up. If that is good you might have to do like I did, used a slide hammer to to pull the axle shaft through a bit more to get the snap ring on.
__________________
--Dave
1999 Rodeo LS 3.2 4x4 5 Speed
32x11.50-15 BFG T/A KO
3" Lift - Rancho 9000x
Rear No-Slip Locker
Flowmaster 2.25" 50 Series
There is a very fine line between "hobby" and "mental illness." - Dave Barry
|